How to build floating shelves? Building invisibly attach floating shelves on walls can be quite easy. DIY building floating shelves can add decorative value to the room. There are references that you can learn from videos or step by step articles like this post. Whether in an alcove including corner of the room, inspiring IKEA floating shelves can be made as learning media. Copying IKEA’s designs of floating shelving to boost your room decor and functionality only is okay.
First of all, cut the panels to become the top and the bottom of the shelving. A fence and a table saw are to set up and cut ½ inch of plywood skins. Another panel identical is to be cut which both as cover for the top and bottom framework. You can decide whether in the same or different lengths based on desire.
18 Photos Gallery of: 10 Steps How to Build Floating Shelves Easily
Second of all, poplar strips are to be ripped on-by-two for the floating wooden shelves’ framework. Rip them identically in width to get similar thickness when assembled on edge to form the finished shelves.
Third of all, other poplar strips are to be cut in one-by-two length. They are meant for each the framework of floating wall shelf. One pair long, one pair short and one cross pair for each. Make sure to measure them well before cutting to fit the skins of plywood.
Fourth of all, gluing and nailing all shelves to put together are the next steps. The correct dimensions in a long rectangle should be mad sure. Then, use a nail gun to secure them all before gluing and nailing to the cross braces.
Fifth of all, the plywood skins are to be glued and set on each framework. It is recommended to apply carpenter’s glue to the framework’s edges. Be sure of the right plywood skin position to be stapled through the skin into the framework. It should be along with the cross braces and perimeter. You can do it the same onto the other side.
Sixth of all, each shelf’s three closed edges are to be faced. Facing strips are to be cut in one-by-two as the cover for each shelf unit’s 3 exposed edges. The ends are to be mitered to form corners neatly. The front piece followed by the end pieces then to be glued and nailed.
Seventh of all, the nail holes should be spackled and all surfaces should be sanded smoothly. To do this step, a putty knife can fill all nail holes which then smoothen by a small sander to the touch perfectly. Get all surfaces ready to be finished.
Eighth of all, each shelving unit’s exterior surfaces are to be painted. Before mounting onto the walls, the shelving units can be finished (or not) depending on personal taste or room decor. In case you want to do the finishing, two coats are recommended. Just let them dry by air.
Ninth of all, on the desired location, cleats are to be leveled and mounted. To get best position for each shelf, be sure to mark both cleat and stud. Pay attention to get them in the same level before screwing into the studs. You do not want to make any mistake in this.
Tenth of all, slip over the hollow opening onto the shelf cleat. On the shelf’s back top edge, counter-sunk screw holes should be pre-drilled. The open back is to be clipped over the cleat which then tapped in place. To secure it through the holes into the cleats, just drive screw them.
Building floating shelves can be easy by following these 10 steps. We are sorry not to show you step by step pictures in how to build floating shelves.