Installing an Crystorama Solaris Chandelier

Jun 6th

Crystorama Solaris chandelier – Replace the plug of a cable is an easy solution, and can save you from having to buy a new extension cord, lamp or appliance. Three – prong plugs have the same two lines as regular outlets leaves little power, and a rounded blade that fits the round hole in the sockets of three slots. The blade rounded is the ground, and helps protect against short circuits and other hazards in the event of a ground fault or a short circuit.

Unique Corbett Lighting Chandeliers
Unique Corbett Lighting Chandeliers

If the crystorama Solaris chandelier of cable you are working with has a ground wire (usually with green plastic insulation), you must use a three – prong plug for replacement. The plugs are available at any home center or in a well – stocked hardware store. Remove the old plug (if easy to do) with a screwdriver. Otherwise, you can simply cut the cable on the base. Cut off any damaged part of the cable using wire strippers / cutters.

12 Photos Gallery of: Installing an Crystorama Solaris Chandelier

Image of: Unique Corbett Lighting Chandeliers
Image of: Tips-Corbett-Lighting-Chandeliers
Image of: Luxury Crystorama Solaris Chandelier
Image of: Instructions Crystorama Solaris Chandelier
Image of: Ideas Crystorama Solaris Chandelier
Image of: Dining Room Corbett Lighting Chandeliers
Image of: Design Crystorama Solaris Chandelier
Image of: Crystorama Solaris Chandelier Tips
Image of: Crystorama Solaris Chandelier Image
Image of: Corbett Lighting Chandeliers White
Image of: Corbett-Lighting-Chandeliers-Ideas
Image of: Awesome Crystorama Solaris Chandelier
 

Disarms the new plug and / or loosen the screws crystorama Solaris chandelier holding the cable. Enter the cable end through the back of the cover and body of the new plug. Reduces few inches of the outer insulation on the cable end, using a knife to mark the insulation and then the wire stripper to cut waste. Cut 1/2 to 3/4 inch (1.3 to 1.9 cm) isolating each of the three wires of the cord, using the wire strippers.